Chimney - Beam Layer Replacement

At the top edge of the dialog box there is again the option to save the dialog box settings under any desired name. Under this name the setting can then be selected and used in the chimney input.

Position: In this field, select the position in which the replacement shall be created.

Ident number: Here enter the identification number of the header members and the filler members, or check the checkbox at the right end of the field. If this checkbox is enabled, the identification number field is deactivated because the identification number of the replaced beams is then adopted automatically.

Width: Enter the width of the header members, or check the checkbox here as well so that the width is adopted from the replaced beams.

Height: Enter the height of the header members, or check the checkbox here as well so that the height is adopted from the replaced beams.

Depth position: This field allows influencing the depth position of the headers within the position selected above. With the options 'flush at top', 'flush at bottom' and 'centered', the header members can be positioned automatically within the position accordingly. With the 'value', the members can be freely positioned and even pushed out of the position.

Replacement direction: For chimneys that are installed at an angle to the beams, this specifies whether the headers should nevertheless be created parallel to the chimney (= angled relative to the beams) or whether they should be created parallel to the X-axis of the ceiling panel.

Connection: Connection between the header members and the beams. You can choose from the stored settings of different connection treatments.